Aeon Labs KeyFob manual

This Key Fob Remote Control can be set up as the primary controller of a Z-Wave network or as an additional Z-Wave controller.

This is perfect for including it as a remote control in an existing Z-Wave network. Each of the four buttons on the Key Fob can

control multiple Z-Wave devices with a simple push and can control up to 8 different scenes.

Installation Guidelines

Slide the rear battery cover from your remote to open the battery compartment.1.

Insert the provided CR 2450 battery into the compartment, ensuring that the + side of the battery is facing up.2.

Reattach the rear battery cover to your remote and firmly close it.3.

Behavior within the Z-Wave network

I On factory default the device does not belong to any Z-Wave network. The device needs to join an existing wireless network to

communicate with the devices of this network. This process is called Inclusion . Devices can also leave a network. This process is

called Exclusion . Both processes are initiated by the primary controller of the Z-Wave network. This controller will be turned into

exclusion respective inclusion mode. Please refer to your primary controllers manual on how to turn your controller into inclusion

or exclusion mode. Only if the primary controller is in inclusion or exclusion mode, this device can join or leave the network.

Leaving the network - i.e. being excluded - sets the device back to factory default.

If the device already belongs to a network, follow the exclusion process before including it in your network. Otherwise inclusion of